Water beading on Poolboy Olefin fabric

Can you use a fabric pool float in a salt water pool?

Yes. A Poolboy fabric float is made for chlorine and salt water pools. Salt water pools are common across Australia, and the only extra step is a quick rinse with fresh water after use, then letting the float dry before you store it.

What salt does to pool floats

Salt water pools make chlorine from salt, so the water is still chlorinated. When salty water dries on a float it leaves a fine crust of salt that can feel rough and attract moisture. On printed PVC, sun, salt and heat together speed up stickiness and cracking. Rinsing it off is the simple fix.

How a fabric float handles it

  • Solution-dyed Olefin. The colour goes through the fibre, so it is not a printed surface that wears off.
  • Sheds water. Olefin does not absorb water, so it dries quickly.
  • Welded core. The air chamber is welded, not glued, under the fabric cover.

Care after a swim

  1. Rinse the float with fresh water from the hose.
  2. Leave it to dry in the shade, not in full afternoon sun.
  3. If you are putting it away for more than a few days, let it dry fully, let the air out and store it somewhere dry.

See our care guide and how to clean a fabric pool float.

What to avoid

  • Leaving a wet float folded in a hot box or shed.
  • Harsh cleaners or bleach on the fabric.
  • Dragging the float across rough pavers or pool coping.

Common questions

Will salt water damage a fabric pool float?

Not with a rinse after use. Salt left to dry on any float is what causes problems over time.

Is a fabric float OK in a mineral or magnesium pool?

Yes. Treat it the same as a salt pool: rinse with fresh water and dry before storing.

Can I leave it in the pool?

Take it out when you are not using it. Sun and water all day, every day, shortens the life of any float.

Shop the Floata-Long, Floata-Round and Sinka-Bit, with free delivery Australia-wide.

Back to blog